Pro Comp Single Bar Roll Bar Cover Kit

• Easy Installation
• Universal Fit
• Weather Resistant
• Velcro for Easy Removal

This roll bar padding and cover kit includes enough padding to cover any single roll bar.
Includes rubber padding with pre-glued edges and tough cover with velcro fasteners.

Instructions for installation:

1. Unpack the Roll Bar Cover Kit which includes four rubber padding pieces with glued edges and two covers with Velcro edges.

2. Starting at the lower edge of the roll bar just about the side of the dune buggy take one piece of padding and wrap it halfway around the roll bar until you reach the center of the roll bar.

3. Place another piece of padding around the roll bar mating the two edges of the previously placed padding.

4. Slowly pull the paper from mating edges to expose the glued edges. Press the two gluded edges together slowly as you continue to unwrap the edge glue strips.

5. Use these two pieces of padding to reach the center of the roll bar. Cut off the excess.

6. Repeat this process on the other side of the roll bar. Cut off the excess.

7. Unroll one of the roll bar covers.

8. Starting at the lower edge of the roll bar even with the previously applied padding place the roll bar cover on the roll bar starting with the logo edge.

9. Slowly connect the Velcro edges being careful work out any wrinkles on the curved areas.

10. Continue to move across the roll bar until reaching the end of the roll bar cover.

11. Repeat this process on the other side of the roll bar starting with the logo end of the roll bar cover.

10. It is okay to overlap the two covers in the center of the roll bar. Use a sharp pair of scissors to cut the material if needed.